␡
- VISM Overview
- MPLS Overview
- RPM Overview
- VISM Voice Features
- Voice Connections
- Voice Over AAL2 Network
- VoIP Network
- Voice Over ATM Services on the VISM
- Digital Signal Processors
- VISM Clocking
- Commands for Adding, Configuring, and Displaying Voice Connections
- Commands for Verifying Voice Connections
- Introduction to Multiprotocol Label Switching
- The Problem of Persistent Loops Due to Protocol Conflicts
- Cisco WAN Switches with MPLS Support
- Setting Up MPLS on the MGX Switch
- MPLS and Virtual Private Networks Using the Route Processor Module
- RPM Memory Locations
- RPM Port Numbering
- Cisco IOS Command-Line Interface
- Commands for Configuring the RPM
- Commands for Setting Up the RPM ATM Switch Interface
- How to Set Up the RPM
- Configuring Subinterfaces
- PVCs on the RPM
- Commands for Configuring Subinterfaces
- Commands for Creating and Displaying PVCs on the RPM
- Creating Connections on the RPM
- Summary
This chapter is from the book
RPM Port Numbering
This section describes how RPM ports are numbered so that when you configure the RPM you can correctly identify the interfaces.
Definition
The port-numbering scheme on the RPM is as follows:
LAN interfaces are identified as chassis-slot/slot/port.
The top-rear interface card is slot 1.
The bottom-rear interface card is slot 2.
Ports are numbered 1 to 4 from top to bottom.
The ATM cell bus interface is always port 1.