␡
- Sun Cluster 3.0 Series: Guide to Installation—Part 2
- Objectives
- Prerequisites
- Major Resources
- Introduction
- Sun Cluster 3.0 Software
- Install SC 3.0 On First Cluster Node—Without Reboot
- Identify the Device ID (DID) on the First Cluster Node
- Verify DID is Available on Each Additional Cluster Node)
- Install SC 3.0 Patches on the First Cluster Node
- Verify the Install Mode is Enabled
- Install SC 3.0 on Additional Cluster Nodes— Without Reboot
- Install SC 3.0 Patches on Additional Cluster Nodes
- Establish the SC 3.0 Quorum Device - First Cluster Node Only
- Configure Additional Public Network Adapters - NAFO
- Configure ntp.conf on Each Cluster Node
- Verify /etc/nsswitch Entries
- Update Private Interconnect Addresses on All Cluster Nodes
- Add Diagnostic Toolkit
Like this article? We recommend
Major Resources
Hardware:
2x Sun Enterprise™ 220R servers (cluster node)
2x Sun StorEdge™ D1000 arrays [6 drives each] (shared storage)
Netra™ T1 (admin workstation)
Monitor (admin access)
Annex Terminal Concentrator (console access)
Ethernet hub (public network)
2x QFE I/O card (private interconnect)
Network: SWAN access
Software: SC 3.0 U3
Services: Sun Cluster