␡
- Sun Cluster 3.0 Series: Guide to Installation—Part 2
- Objectives
- Prerequisites
- Major Resources
- Introduction
- Sun Cluster 3.0 Software
- Install SC 3.0 On First Cluster Node—Without Reboot
- Identify the Device ID (DID) on the First Cluster Node
- Verify DID is Available on Each Additional Cluster Node)
- Install SC 3.0 Patches on the First Cluster Node
- Verify the Install Mode is Enabled
- Install SC 3.0 on Additional Cluster Nodes— Without Reboot
- Install SC 3.0 Patches on Additional Cluster Nodes
- Establish the SC 3.0 Quorum Device - First Cluster Node Only
- Configure Additional Public Network Adapters - NAFO
- Configure ntp.conf on Each Cluster Node
- Verify /etc/nsswitch Entries
- Update Private Interconnect Addresses on All Cluster Nodes
- Add Diagnostic Toolkit
Like this article? We recommend
Prerequisites
This lab manual assumes you are a qualified Solaris™ network administrator. Additional pre-requisites include: ES-333, or equivalent. The intended audience for this module is sales engineers, system support engineers, professional service consultants, and system administrators. For installation queries, shell usage questions, patches and packages refer to the Sun Educational Services manuals for the "Solaris System Administration 1" and "Solaris System Administration 2" courses.