Sun Cluster 3.0 Series: Guide to Installation—Part 2
- Sun Cluster 3.0 Series: Guide to Installation—Part 2
- Objectives
- Prerequisites
- Major Resources
- Introduction
- Sun Cluster 3.0 Software
- Install SC 3.0 On First Cluster Node—Without Reboot
- Identify the Device ID (DID) on the First Cluster Node
- Verify DID is Available on Each Additional Cluster Node)
- Install SC 3.0 Patches on the First Cluster Node
- Verify the Install Mode is Enabled
- Install SC 3.0 on Additional Cluster Nodes— Without Reboot
- Install SC 3.0 Patches on Additional Cluster Nodes
- Establish the SC 3.0 Quorum Device - First Cluster Node Only
- Configure Additional Public Network Adapters - NAFO
- Configure ntp.conf on Each Cluster Node
- Verify /etc/nsswitch Entries
- Update Private Interconnect Addresses on All Cluster Nodes
- Add Diagnostic Toolkit
Sun Cluster 3.0 Series: Guide to InstallationPart 2
This module reviews the Sun Cluster™ 3.0 concepts and components important to these specific procedures, as it describes the method of constructing a cluster. This is accomplished by installing the cluster software onto each node, then configuring the disks.
NOTE
Allow enough time to complete the cluster installation and configuration procedures. To build this Sun Cluster 3.0 two-node cluster, software can be installed using a variety of methods; however, the configuration procedures must be performed in the exact sequence shown. For this reason, the procedures included in later modules are intended to be performed consecutively, and following the prescribed sequence of operations.