␡
- Introduction
- Booting a System
- The OpenBoot Environment
- The OpenBoot Architecture
- The OpenBoot Interface
- Getting Help in OpenBoot
- PROM Device Tree (Full Device Pathnames)
- OpenBoot NVRAM
- OpenBoot Security
- OpenBoot Diagnostics
- OpenBoot PROM Versions
- Booting a System
- The Kernel
- The init Phase
- System Shutdown
- Summary
- Suggested Readings and Resources
This chapter is from the book
The OpenBoot Interface
Objective: Execute basic boot PROM commands for a SPARC system.
The OpenBoot firmware provides a command-line interface for the user at the system console called the Forth Monitor.
The Forth Monitor is an interactive command interpreter that gives you access to an extensive set of functions for hardware and software diagnosis. Sometimes you’ll also see the Forth Monitor referred to as new command mode. These functions are available to anyone who has access to the system console.
The Forth Monitor prompt is ok. When you enter the Forth Monitor mode, the following line displays:
Type help for more information ok