- Equipment List
- Setting Up the Lab
- Pre-Lab Tasks
- General Guidelines
- Practice Lab 1
- Section 1: Bridging and Switching (15 Points)
- Section 2: IP IGP Protocols (28 Points)
- Section 3: ISDN (8 Points)
- Section 4: EGP Protocols (17 Points)
- Section 5: Voice (6 Points)
- Section 6: DLSw+ (4 Points)
- Section 7: IOS and IP Features (10 Points)
- Section 8: QoS (8 Points)
- Section 9: Multicast (4 Points)
- Practice Lab 1: "Ask the Proctor"
- Section 1.1: Frame Relay Configuration
- Section 1.2: 3550 LAN Switch Configuration
- Section 1.3: ATM Configuration
- Section 2.1: RIP
- Section 2.2: EIGRP
- Section 2.3: Redistribution
- Section 3: ISDN
- Section 4: EGP Protocols
- Section 5: Voice
- Section 6: DLSw+
- Section 7: IOS and IP Features
- Section 8: QoS
- Section 9: Multicast
- Practice Lab 1 Debrief
- Section 1: Bridging and Switching (15 Points)
- Section 2: IP IGP Protocols (28 Points)
- Section 3: ISDN (8 Points)
- Section 4: EGP Protocols (17 Points)
- Section 5: Voice (6 Points)
- Section 6: DLSw+ (4 Points)
- Section 7: IOS and IP Features (10 Points)
- Section 8: QoS (8 Points)
- Section 9: Multicast (4 Points)
Section 1.3: ATM Configuration
Q: What kind of subinterface do you want on R6?
A: There are only two routers connected over ATM; choose a suitable subinterface type to reflect this.
Q: When you say latest method of configuration, do you mean using the pvc command?
A: Yes.
Q: When you say legacy configuration, do you mean using the map-list command?
A: Yes.
Q: What ATM encapsulation should I use?
A: This is a back-to-back configuration so use a suitable type of your choice.
Q: Do you want me to configure "broadcast" under my ATM interfaces?
A: You need to determine what type of traffic/protocols will use the ATM network.