- Equipment List
- Setting Up the Lab
- Pre-Lab Tasks
- General Guidelines
- Practice Lab 1
- Section 1: Bridging and Switching (15 Points)
- Section 2: IP IGP Protocols (28 Points)
- Section 3: ISDN (8 Points)
- Section 4: EGP Protocols (17 Points)
- Section 5: Voice (6 Points)
- Section 6: DLSw+ (4 Points)
- Section 7: IOS and IP Features (10 Points)
- Section 8: QoS (8 Points)
- Section 9: Multicast (4 Points)
- Practice Lab 1: "Ask the Proctor"
- Section 1.1: Frame Relay Configuration
- Section 1.2: 3550 LAN Switch Configuration
- Section 1.3: ATM Configuration
- Section 2.1: RIP
- Section 2.2: EIGRP
- Section 2.3: Redistribution
- Section 3: ISDN
- Section 4: EGP Protocols
- Section 5: Voice
- Section 6: DLSw+
- Section 7: IOS and IP Features
- Section 8: QoS
- Section 9: Multicast
- Practice Lab 1 Debrief
- Section 1: Bridging and Switching (15 Points)
- Section 2: IP IGP Protocols (28 Points)
- Section 3: ISDN (8 Points)
- Section 4: EGP Protocols (17 Points)
- Section 5: Voice (6 Points)
- Section 6: DLSw+ (4 Points)
- Section 7: IOS and IP Features (10 Points)
- Section 8: QoS (8 Points)
- Section 9: Multicast (4 Points)
Section 1.2: 3550 LAN Switch Configuration
Q: Do I have to configure the switch as a VTP server?
A: The questions do not ask you to do this and there is only one switch in the network.
Q: Why can't I rename VLAN1?
A: You can't so don't waste time on this.
Q: Can I leave my switch ports in auto mode?
A: The questions do not specifically ask you to configure speed and duplex, but you should do this to avoid any mismatches that could cause you problems.
Q: For the future port 0/16, can I leave it in VLAN1?
A: There is no specific VLAN stated in the question, so yes.